Invasive Mussel Prevention

Vessel Inspection Program

EBMUD’s boat inspection program includes two parts: a history survey, followed by a physical inspection. Boats that fail either the survey or the inspection cannot be legally launched in EBMUD reservoirs.

Vessel History Survey - If your vessel is coming from an area of high risk it will not be allowed to launch in EBMUD reservoirs. Vessels will fail the vessel history survey and not be allowed to launch for the following reasons:

  • The vessel comes from a high risk area. High risk areas are defined as the general areas where positive identification of one of the mussel species has been documented. At this time, this includes all counties of Southern California and all vessels from outside of California. County of origin is determined by vessel registration documents.
  • Vessels having been launched on waters in the high risk areas (see above) within the past 30 days will also not be allowed to launch.
  • Boat operator fails to comply with any aspect of the inspection process.

The list of areas deemed as high risk will change over time as new detections of mussels are made. If your vessel does not pass the vessel history survey and you wish to find out about how you may be able to launch in the future, contact the management at one of the reservoirs to find out if vessel cleaning and a 30 day quarantine program is available. Vessels passing the vessel history survey will then normally progress the physical vessel inspection.

Physical Vessel Inspection - If your boat is coming in to one of EBMUD's reservoirs it may be subject to physical inspection prior to being authorized to launch. Inspections are performed by qualified EBMUD staff and take approximately five minutes to complete. Vessels will fail the physical vessel inspection and not be allowed to launch for the following reasons:

  • Standing water is found in live wells, bait wells, bilge areas, any container possessing live bait, or any other portions of a vessel.
  • Water drains out of an engine when outboard motor or out-drive is lowered into the vertical position.
  • Vessel is found to have mussels or other aquatic invasive species attached to some portion of the vessel. Department of Fish and Game will be notified if Quagga or Zebra Mussels are suspected.
  • Boat operator fails to comply with any aspect of the inspection process.

To help expedite the vessel inspection process, you can print and complete a vessel inspection form prior to your arrival.  The document below is a PDF file, which can be viewed and printed with Adobe Acrobat Reader, a free software.

Vessel Inspection Seal Program

Vessels leaving the launch ramp or gate may elect to have a vessel inspection seal placed on their vessel, which will allow them to re-enter any EBMUD reservoir without having an additional physical vessel inspection. However, some vessel/trailer configurations preclude the proper placement of the seal. Additionally, in some instances a qualified inspector will not be available at the time of departure. In these events, the vessel will need to be re-inspected upon re-entry. Vessels arriving at the launch ramp or gate with a properly installed vessel inspection seal will still need to complete a vessel history survey but will not need a new physical vessel inspection. EBMUD maintains a reciprocal banding agreement with other reservoirs who agree to adhere to the same inspection standards.

EBMUD is asking all boaters to follow the California Department of Fish and Game guidelines for mussel prevention.

How Boaters Can Help (excerpts from DF&G)

Boaters should check their boat, trailer and vehicle every time a boat is taken out of the water.

  • Inspect all exposed surfaces vehicle, trailer, anchor, dock lines, live wells, bilge, motor, hull, trailer axle and rollers). Small mussels feel like sandpaper and are invisible to the eye.
  • Wash the hull of each watercraft thoroughly (steam clean if possible).
  • Remove all debris, plant and animal material.
  • Drain all water and dry all areas.
  • Drain and dry the lower outboard unit.
  • Clean and dry all live-wells.
  • Empty and dry any buckets.
  • Dispose of all bait in the trash.
  • Wait five days and keep watercraft dry between launches into different fresh waters.

Thank you for your vigilance, support and patience in keeping our waters free of invasive mussels.

Related Links

Additional Information